FLP-11 Onager- Absurd Long Draw Foam Blaster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Onager is, I'm pretty sure, the longest draw springer blaster to exist. This takes two K25s end to end. Enough said.
- Ocena
- 0 / 5
- Polubienia
- 72
- Pobrania
- 67
- Wydruki
- 3
- Wyświetlenia
- 1405
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Share Alike
Onager is a 34cm draw foam dart blaster. It's pump action and is carried over the shoulder; it is fed from a top mounted Talon magazine. Using two K25 springs end to end, it can achieve close to 400 fps. The actual FPS ceiling of this blaster is untested, because optimal barrelling is very hard to achieve... this is because you're probably going to need about 4 feet of barrel.
This is probably the longest springer to exist. This is probably the longest draw springer to exist. It's also probably the easiest prime you'll ever feel for its power, and due to the over the shoulder layout, elevation is super easy and it functions basically as artillery.
Availability:
BearsWares has kits here: https://bearswares.shop/products/onager-by-shoelesshistorian
Print Settings:
4 walls, 20 percent infill for primary and secondary colors.
All walls, 100 percent infill for everything orange, except for muzzle at 4/20.
Print the ram and buttpad out of TPU; all walls 100 percent infill for the ram, 2 walls 10 percent infill for the buttpad.
Build Guide
https://imgur.com/a/onager-build-guide-6-20-26-Rawhjj2 Note you will need a long hex wrench for the muzzle screws.
Materials required:
4x M4 threaded rod, 750mm
Threaded Rod - M4 x 250
55cm prime bar, Rush drill pattern
Linear Rod - 8 x 450mm
2x Linear bearings - 8mm bore 15mm OD 24mm length
37cm plunger tube
2x K25 springs
3x O Rings - 123
2x O Rings - 016
2x O Rings - 012
2x small weak springs for mag release and catch
16x Hex Nuts - M4
3x Lock screws - 10-32 x 5/16
3x Hex Nut - 10-32
3x Ball Detent - 6x7mm
40x M3 Screws - 8mm
7x M3 Screws - 6mm
4x M3 Screws - 25mm
2x M3 Screws - 16mm
1x M3 Screws - 10mm
7x Hex Nut - M3
1x 16mm OD barrel... 4 feet 13mm ID is a good place to start.
Optionally, 120mm cut of 16mm barrel material for a spring guide. There's a printed version in these files.
Acknowledgements:
Once again, huge thanks to Bear for handling kits, helping with beta, prodding me along here. Frozenfade, the greatest hype man and teammate anyone could ask for. Bird, Poppy, Silvernutter, Albe, Senrath... hopefully I didn't forget anyone, but it's been a great group of beta testers. Evan, thanks for the spring coupler help! Shout out to Marko, who was the first victim of a sustained Onager barrage at a USFT game.