1/10 Scale RC Car Wheels for 1/4" D-Shaft
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A design for 1/10 scale RC car wheels using TPU tires that uses 1/4" D-Shaft and is 120 mm in diameter.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 25
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
A design for 1/10 scale RC car wheels using TPU tires that uses 1/4" D-Shaft and is 120 mm in diameter. They were intended for use on a custom design that was actually not an RC car for competing in the AiChE Chem-E Car Competition, but they should be repurposable to some extent. There are two formats where one requires snug supports on the spokes while the other doesn't. This is because the supported one has the spokes centred with an additional protrusion to slot into a bearing for supporting the wheel/axle mount while the unsupported one has just a straight shaft and has the spokes on the edge of the wheel, touching the print plate. The intent was that these would be rear and front wheels respectively.
The design has a hole in the hub for an M4 threaded insert as well as a corresponding hole in the rim for installation to use a grub screw to lock it on the D-profile of the shaft. The hubcap is just for decoration, but I embossed a fireball logo on there. The TPU tires are purposefully made to be an interference fit to prevent slip and have no treads as these tires were intended to be used on an indoor track without weather. I would recommend printing the rims with 4 walls and 15% cubic infill or higher and the tires with 2 walls and 15% grid infill. The hubcaps' settings are not particularly important.
This model was created using Fusion 360.