1 / 7
Desiccant Bin for Qidi Box — No Screws, 100% Snap-Fit - Q2 bed compatible. — zdjęcie 1
1 / 7

Desiccant Bin for Qidi Box — No Screws, 100% Snap-Fit - Q2 bed compatible.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Screwless, 100% snap-fit desiccant reservoir for the Qidi Box — holds ~180-200g of silica gel.

Ocena
0 / 5
Polubienia
15
Pobrania
72
Wydruki
0
Wyświetlenia
376
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

Here's the V2 of this desiccant reservoir for the Qidi Box, as promised. It maximizes the available footprint of the Q2's bed (270 mm) along with the height and thickness available inside the box.

Fully screwless assembly — 100% snap-fit. You only have to remove original bins before :-)

Fill it through a self-locking hatch.

A funnel is included as a bonus!

Approximate capacity: ~180-200 g of silica gel beads.

Printing

  • I used PETG. The base measures 270 x 103 mm — a large flat part with no room for mouse ears and no free corners for a brim (the bed footprint is maxed out). PETG shrinks much less than ABS and holds down reliably on this geometry.

  • ABS is an option if your enclosure and bed adhesion setup can handle it, but expect severe warping on a part this size under those conditions.

  • If your box's operating temperature exceeds what PETG can safely handle (HDT around 70-80°C), PETG is no longer recommended in that case — though it may still work, a higher-temperature-resistant filament (e.g. ABS, ASA, or PC) is the safer choice.

  • Supports are optional on the filling hatch — depending on your filament you may be able to skip them, but expect a cleaner result with supports on.

Print settings

Setting

Value

Nozzle

0.4 mm

Layer height

0.2 mm

Wall loops

2

Infill

15%, grid

Assembly

  • Gluing the base to the perforated panel is required, not optional. This joint isn't held by the snap-fit alone — use a suitable adhesive (e.g. cyanoacrylate/super glue for PETG) to secure it permanently.

  • Color choice (opaque, clear, or mixed between parts) is entirely up to you.

Tips

  • Use the included funnel to make filling with desiccant easier.

  • The original screw holes are no longer needed — if you have some on hand, a bit of metal (aluminum) tape works well to seal them off.

Tagi