Fin for SUP BAX Astronave or A&BBOARD or ANYFAST
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fin that is now impossible to find on the market, completely out of current standards.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 26
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
For anyone who bought the latest clearance SUPs in 2025 (BAX Astronave, A&BBOARD, or ANYFAST) and lost the fin, this is the solution to get back to using our beloved SUP.
I started from an image of the original fin (now lost) and, thanks to AI, had a base 3D shape reconstructed. With the help of calipers, a lot of patience, and several failed prints, I managed to design the mount for the base. From there, everything is easier... you can choose one of the fins already available on this site and attach it to the mount, or you can print mine directly.
This is the original shape. If you are looking for the shark fin to print horizontally, check out my profile.
Print Settings:
Use PETG (PLA is not recommended for saltwater use)
Set at least 4 walls
Use at least 40% infill
Gyroid infill pattern
Supports and a wide brim (or a raft) are required to prevent it from warping or detaching from the print bed
By orienting it correctly, it can be printed on a 220x220 mm bed (see project files)
Note: If it doesn't fit snugly, use a small file on the fin connector to slightly lower the vertical joint or shorten it (by no more than 1 mm) — it's better to remove material than to add it... The clip must return completely to its resting position. And be careful not to lose it again!
Please note that I haven't printed this exact model yet. If anyone prints it, I'd really appreciate some photos and feedback.