Bottomless Portafilter Stand (De'Longhi 51mm 2-ears)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stand for modified De'Longhi Stilosa (51mm 2-ears) portafilters
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 92
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
Stand made for modified De'Longhi Stilosa (51mm 2-ears) portafilters. The bottom has three spots for 12mm rubber feet.
NOTE : A stock, unmodified portafilter will not fit this stand. This is made specifically for modified Stilosa portafilters with the bottom cut off.
Should work with most bottomless portafilters compatible with the Stilosa, although you might need to adjust the handle support height/angle.
If you want to make it more stable, print the base with a higher infill density (i.e. 80%). It also feels a bit more "premium" that way even though it's 3D printed.
Since this holds the portafilter, you should make this out of a filament that supports higher temperatures. Materials with low glass transition temperatures (like PLA) might warp or deform when holding a preheated portafilter.