Mini Rack Add-on Parts

This collection of parts was created to customize my Mod10 Server Rack originally designed by @MandicReally. This collection adds parts that fit with the Mod10 design aesthetic, but could also be used on other mini racks.

One of my rack objectives was to consolidate all power supplies into one power strip that is zip-tied to the back of my rack using the mounts. I also chose a 10A 12v power supply so all 12v consumers could run off of the same power supply, with amps of ceiling room. Doing this, I only have one cord to plug into the wall, and many ethernet runs that go out to devices. This keeps wire organization as clean as possible.

Mini Rack Components for Specific Hardware

• Tray for Netgear GS308PP PoE Switch

• Tray for pfSense (a very old one!)

• Tray for Raspberry pihole for a pi4 with Pi-UpTime UPS 2.0 support, and 2x 21mm rocker switchs and 12v-to-5v buck converter

• A lid for the Mod10 that supports a Telekom SpeedPort Pro Plus home DSL router. (Mod10 specific)

General Organization Parts

• Cable Tie points built into the Mod10 supports (Mod10-Mini-Server-cable-tie.stl)

• Rear shelf supports with 1, 2, 3, or 4mm of rise.

• Power supply mounts with ziptie-connector in 25, 30, or 38mm arm lengths.

See my pics for how you can use these. They should work with most mini-racks that have the same hole spacing as the Mod10, except for the lid. The lid has holes that exactly match the Mod10 geometry.

Printing

Print them using the same settings you used for the Mod10 (something like 5 perimeters and 20% infill).

Use PETG, ASA, or other higher temp filament. PLA will warp from the heat of the electronics inside.