1 / 17
TX16s Case Box Handle Latch — zdjęcie 1
1 / 17

TX16s Case Box Handle Latch

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a latch and handle print made for the TX16S foam case

Ocena
0 / 5
Polubienia
1
Pobrania
5
Wydruki
0
Wyświetlenia
35
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

Material needed:

Instructions:

Enable Ironing en the last layer for a better finish.

If the screws are too tight, instead of forcing them, heat them with a lighter to easily drive them into place.

Assemble the gimbal spring to the spring operator and the spring case using the 2 M2x4mm self-tapping screws as shown in pictures 2 and 3.

I designed the inner and outer reinforcements to prevent overloading the handle base in the layer plane. Please be careful to insert them exactly as shown in Picture 4, ensuring the parts with the larger holes are fitted into the outward slits and the ones with the smaller holes into the inward slits.

Screw the spring case assembly to the handle base using the 2 M2.3x8mm self tapping screws as shown in picture 5.

Use a small round file to cut out the holes for the Chicago rivet screws as shown in Picture 6.

Before attaching the handle base assembly to the case with the Chicago screws, insert the handle into place and secure it with the M3 bolts as shown in picture 7. Heat if needed.

Attach the handle base assembly to the case with the Chicago screws as shown in picture 8.

Use the cutting jig shown in picture 9 to drill the holes and cut the groove to fit the latch hook.

Attach the latch hook to the case using the Chicago screws and check if the top and bottom parts latch correctly.