N: DIY-Catenary pole base for viaducts

This is an Add-on to my DIY-viaducts for Kato’s Unitrack of standard width:By gluing these pieces to your viaduct, you may equip it with Kato’s catenary poles. Please note, that this is made for my DIY-viaducts only. For original Kato-viaduct track you should use Kato’s catenary pole bases, namely in this case 23-056.

There are two versions:

a) one for a distance of 18mm from centre of track to centre of pole. You may use this with the normal wide double track viaduct on both sides. This would correspond to a distance of 69mm from pole axis to pole axis and would allow to use double track poles like 23-060.

b) one for a distance of 20mm from centre of track to centre of pole, that is made exclusively for my wider version of viaduct and by obvious reason will go only with single track poles like 23-059

Hope you enjoy these extended possibilities to create viaducts and ramps with KATO’s great track system. Happy printing and a lot of fun with your model railway layout!

Please note:
KATO’s Unitrack is the first and only choice in n-scale for mobile layouts and one of the best track systems in general:
https://unitrack.katomodels.com/what_is_uni_track
But “Kato” and “Unitrack” are trademarks of K.K. Sekisui Kinzoku, Japan and are used for reference only. The design presented here is neither supported nor authorised by the before mentioned trademark holder.

Please note the license:
My design is published under the CC BY-NC-SA license, which means that you can freely use this model for any non-commercial purpose and may remix this model freely as long as you provide attribution and share with the same creative commons license. Feel free to contact me if any questions.