DIY - Desk lamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have for some time wanted to get a new desk lamp, but i have not been able to fine one that i liked and that used…
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 1072
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
I have for some time wanted to get a new desk lamp, but i have not been able to fine one that i liked and that used led's so i decided to make my own, so here it is.
There is a picture with some red parts that show some different versions of parts and print settings.
Se instructions for print-settings and material's used.
Instructions
Print one of all the parts.
My print settings:
0.1 mm layerhight, PLA filament, 210 nozzle temp, 60 bed temp, 30 mm/s print speed, simplify3d slicer, 1 mm support pillersize(silplify3d setting), 30 deg support angle, From bed support, 100% infill.
I have also added a block to help drill into the tubes.
Parts
14x m3 10mm countersunk screws (7 cut down to 4-5 mm)
3x 10mm 1m long alu tube
1x 30x15mm 1m long L-shape alu profile
the alu parts did a buy at a local hardware shop.
Category: Office