Cisco 9841/9851/9861/9871 Phone Wallplate Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wall mount for the Cisco 9800 series of phones that mounts to an existing phone wallplate.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 79
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Open Community License v1.1 + General Attribution v1
A simpler wall mount for the Cisco 9800 series of phones, at least compared to my other design. Check out that one if you need the phone to be secured to the wall.
This mounts on either a phone wallplate or on two screws, spaced 100mm or 3 15/16" apart. It'll accommodate screws up to M5 or #10.
You'll also need 3 - M3 x 12mm or M3 x 16mm, or 3 - #6 x 1/2" or #6 x 5/8" sheet metal or wood screws to attach it to the phone. If you're in the US, here's a couple places you can buy them:
The mount was designed to be printed in ABS, but most other filaments should also be fine. It can be printed without generated supports if printed in the original orientation. Generated supports are a bit difficult to remove with the way the holes are designed. I printed this out with 3 walls, 4 top and bottom layers, and 20% infill.
There's two versions of this mount: one with built-in supports and one without supports. Try the one without supports first. If the areas behind the mounting holes don't print nicely, then print the one with the built-in supports. After printing, the built-in supports can be removed with a small screwdriver, needle-nose pliers, or flush cutters.