xTool F2 Riser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple riser for the xTool F2 laser engraver. This makes using the RA3 rotary with larger cups possible.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 94
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
This is a simple riser for the xTool F2 laser engraver. I had a difficult time using the RA3 rotary tool on larger tumblers because the laser couldn't lift high enough to focus. The easy work around is to set the laser on top of the RA3 instead of on the build plate but this makes the machine unstable and wobbly. I didn't want to pay for a file for a riser so I spent an evening with ole ChatGPT (I am awful with CAD software) working on a design that solves the above problem.
I have ran several test prints to ensure fitment. The legs as well as the base itself fit together and on my machine well. I left a small amount of tolerance on the leg pegs so they should work on less tuned printers. My printer is about as dimensionally accurate as I can get it and the pegs still stay in place. If they don't fit correctly try adjusting the scale by a percent or so in either direction.
On the legs if you use supports, don't bother pulling them out of the middle, they don't interfere with anything. There are two different leg files, the short legs pick the machine up about 20mm. I find this to be about the tallest I care to pick it up, and more often than not I just use the base of the riser flat on the table unless I'm workin with a really large item. There is also a file for taller legs, use the cut tool in your slicer on these to make a set of legs at any height you want! Print 4 legs! If they are used on a slick table top the legs can slide around. You can either print out some TPU booties for them or add some other anti-slip item to the bottom of the legs. I used 3M double sided tape that I purposely dirtied one side of. DONT ACCIDENTLY SLIDE YOUR THOUSAND DOLLAR LASER OFF OF YOUR TABLE!
The RA3 cutout is sized a little bigger than the rotary to allow you to shift it around some. There is another model on my page that is a jig to align the rotary with the correct lines on the F2.
Alignment Jig-
Pictured is the short legs and flat on the table.
Settings- I used PETG 3 Walls, 25% Rectilinear Infill, and Auto Slim Tree Supports.