Qidi q2 upgraded bed screw holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
better bed clearance, more reliable probing, and thickened up for more rigidity
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 38
- Wydruki
- 1
- Wyświetlenia
- 244
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
The qidi q2 inside is a very cramed printer chasis, and the factory bed screw holders have a tendency to catch/ rub on the bed causing leveling issues and probe errors.
these upgraded lead screw holders provides better clearance from bed (extra 1mm in) while still staying aligned to spec and is thickened it up for extra rigidity
ive added two versions, one more true too stock width with hole for auxiliary blower
second wider stronger version, which may partially block air flow, however i suspect this is very negligable and highly recommend this one over the first.
will require m3 heat inserts for each mounting hole
I managed to remove the old one and place the new thicker one in without removing the aux fan or the left ap board cover. I placed it on the lead screw first then tilt slid it into position over the fan duct/cover. if you do not have as much finesse and dexterity as me, you could just remove the aux fan duct first for easier install 😁
I've printed in unfilled PC printed at 70c chamber temps for good layer adhesion. And orientated on side. 0.6 nozzle (0.4 may be better) 0.18 layer height and full infill and max walls