Elegoo CC1 Canvas Topper (Must Be Used With A Riser) (2 Versions)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple topper for the CC1 Canvas Upgrade Center Mount or Lowered. Works with my center mounted Canvas.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 226
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple topper to eliminate noise, may also be used for heat retention. Designed to be used with my center mounted canvas design. It may work with a lowered canvas also but would need a riser on the top for tube clearance. Utilizes the original glass top but must be used with a riser if used with any canvas mounting location. Designed to fit the inside recess of the printer top, all glass tops should fit (not all glass tops are the same size). Before I installed the canvas I had printed a vented riser and decided to build off of that. This is also how I found out most risers were designed around glass size and not printer top opening. A story for another day, just be aware that not all risers were designed with the correct dimensions.
The cover for the right side proved to be difficult to print so I included a 2 piece design that was far easier to print. Also included is a Snub Nose design that will likely prove to be the preferred version. The extended version would work better when used for non restrained ptfe tubes as there is room for tube travel and no impact of tubes would occur obviously providing less noise. I did not print or test the Snub Nose version as the extended version was my first version and there was no need for me to reprint it.
The cover and plate are to glued on. The cover needs to be printed with normal supports. The plate was designed with openings for ptfe tubes. My main concern was noise heat retention is an added plus.
The filler pieces for front and rear sides are to block light and can also be glued in for additional strength. Not required for strength but an option for light bleeding through any gaps.
I use tinkercad and it definitely has it's limitations but the topper turned as I expected and does what I needed it to do.
Things to note:
Must be used with a riser with at minimum of 64mm height if used with my center mounted canvas design. Your setup may require something different.
Risers used with this may not work if they were designed to fit the designers glass top and not the printer top glass recess.
PTFE tube lengths will need to be determined by you based on your setup. Original tube length is slightly modified from the original.