1 / 3
Lian Li A4-H2O riser feet with holes for Power & HDD LEDs. — zdjęcie 1
1 / 3

Lian Li A4-H2O riser feet with holes for Power & HDD LEDs.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Lian Li A4-H2O riser feet with holes for Power & HDD LEDs.

Ocena
0 / 5
Polubienia
1
Pobrania
1
Wydruki
0
Wyświetlenia
58
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I modeled these because I wanted Power and HDD LEDs in my Lian Li A4-H2O case. I could drill between the case power and USB-C in the chassis frame, but I thought making riser feet might be easier and add 10mm more clearance at the bottom for increased air flow. You will have to drill a hole in the bottom chassis frame (hidden by the feet) to pass the wires/LEDs through. These use the stock rubber feet cut to fit and inserted into slots in the riser. Glue as you see fit. The stock feet are 7mm high, these make it 13mm. For the rear riser 2.5mm will have to be cut of of each end of the rubber. For the front riser do the same, then you will have to cut the middle out to fit the slots in riser. Remember, measure six times, cut once. (Or you can make new rubber feet out of something else.) You'll also have to get longer screws. I included a .stp, and the Rhino 8 .3dm file for those who might want to make changes in the native format.