Push Blade Attachment for Professor Boots V2 RC Excavator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a push blade for the larger excavator.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 260
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an updated base with channels for the push blade arms, plus an upscaled, updated version of the smaller push blade. I didn't add channels for the wires, but they're very short and don't get in the way.
You will need:
One 21 mm actuator (7 or 9 mms) and the two included screws.
Two m3 * 12 screws to connect the mounts to the blad arms
Four m3 * 10 screws to connect the arm mounts to the base
To cut your actuator wires and solder them to the remaining wires from the slip ring
To connect the wires to AUX1 to control the movement using the square and circle buttons.