Coin coaster Namibia 50c
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Realistic Namibia 50c coin as a coaster This is a replica of a Namibia 50c coin for use as a coaster. The diameter is…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 198
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution — Noncommercial
Realistic Namibia 50c coin as a coaster
This is a replica of a Namibia 50c coin for use as a coaster. The diameter is 10.1 cm (3.9 inches). The back side is flat with 3 round insets with 10 mm (0.4 inches) diameter each. You can glue some rubber into the insets to make the coaster sit on the table in a stable way. However, the coasters of course also work without the rubber support.
You can use any filament color which you like for the Namibia 50c coaster. The original color of the 50c coin is a light silver.
If you do not want to glue rubber into the coin, please use the model "Namibia_50c_no_holes_01.stl".
Print Settings
Printer:
FLSUN Super Racer
Rafts:
No
Supports:
No
Resolution:
0.15 - 0.2 mm layer height
Infill:
20 %
Filament:
Any Any filament your printer can handle
Any
Notes:
Let the back side of the coin with the 3 holes lay on the build surface of your printer.
For Cura slicer you can set the "Infill" -> "Minimum Infill Area" to 4000.0 mm2 to create a clean coin base without strange infill spots for the top letters.Post-Printing
Glue round rubber or foam sheets (optional)
You may want to glue 3 round 10 mm (0.4 inches) rubber or foam sheets with 2.5 mm thickness to the bottom holes. This will make the coaster sit on the table in a stable way.
How I Designed This
Coin design
The coin was designed with Blender. I have designed the flat base coin first. Using a reference photo I have extruded points to match the text and ornaments on the top surface.
Category: Coins & Badges