Handle for ATX Lab Bench Power Supply
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
handle for the Upcycled ATX Lab Bench Power Supply so its more suitable for travel or frequent moving
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 61
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I haven't printed it yet because the whole lab power supply project is still in progress, but I will update this remix with photos once the power supply is fully assembled.
I designed a handle for the lab power supply to make the case much easier to carry.
To mount this handle to the existing enclosure:
Drill two holes into the bottom of the case (as you can see on the picture), spaced 3 cm apart somewhere where is the center of gravity of your power supply (its different for each PSU).
Install M3 threaded inserts (the same ones used to build the power supply).
Tip: Mark the hole positions directly through the printed handle before drilling.