Ferris (Rust Mascot Crab) Pins

A small pin featuring Ferris, the Rust programming language mascot 🦀.

The model is printed flat and only requires a standard pin post and clutch to turn it into a wearable pin.

Looking for more Rust? Check out the matching Rust Logo Pin

Bill of Materials

You will need:

• Pin post with (butterfly) clutch

• A small amount of glue

Instructions

Each pin consists of:

• 1 printed ferris

• 1 pin post/back

• 1 pin clutch

Assembly is very simple, you only need to glue the pin post to the center of the back of the printed part. Let the glue dry and add the pin clutch.

Make sure the surfaces are clean before gluing, and avoid using too much glue as it may spread around the pin post.

Coloring

The design of the pin is made to be easily colored using height coloring (manual color swap friendly).

Printing recommendations

• Use a 0.2 mm or 0.4 mm nozzle with the Arachne wall generator enabled in your slicer for the best results.

• If you experience adhesion issues, make sure your build plate is thoroughly cleaned.

Design

• This model is based on Ferris the crab, the unofficial mascot of the Rust community.

• The original Ferris artwork by Karen Rustad Tölva is available from rustacean.net and has been dedicated to the public domain.

• This is an unofficial, community-made design and is not affiliated with or endorsed by the Rust Project or the Rust Foundation.