Raspberry Pi Touch Display 2 10" In-Wall Flush Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounting hardware for installing a Raspberry Pi Touch Display 2 10" flush mounted in a stud wall.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 253
- Wydruki
- 0
- Wyświetlenia
- 1158
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Mounting hardware for installing a Raspberry Pi Touch Display 2 10" flush mounted in a stud wall so that only the bezel sits proud of the wall surface.
Consists of two parts - a box which can be recessed into the wall, and cylindrical "pegs" that screw into the mounting holes on the back of the display and slide over the corresponding posts in the box to install the display. This is a friction fit so you may need to slightly tweak tolerances to get the tightness you require.
Check the tightness of the fit before installing the box in a wall, otherwise you risk forcing the display in and not being able to pull it out again if it's too tight!
Also includes a printable template to cut around to make the exact size hole required in a wall.