1 / 3
Donner Hush-X Heavy-Duty Drywall Mount (Hidden Screws & Extended Base) — zdjęcie 1
1 / 3

Donner Hush-X Heavy-Duty Drywall Mount (Hidden Screws & Extended Base)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Reinforced drywall mount for Donner Hush-X with extended leverage, wide base, and flush snap-in screw caps.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
39
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Public Domain

OVERVIEW

This is a heavy-duty, drywall-optimized remix of the Donner Hush-X guitar wall mount.
While the original cradle holds the Donner Hush-X guitar body securely, mounting it on drywall (plasterboard) with standard screws posed a significant
leverage and pull-out risk due to the short distance between mounting holes (only 70 mm).
This redesign extends the footprint into an elongated, rigid 60 x 230 mm vertical spine with a fully hidden fastener system, making it rock-solid on
drywall while maintaining a clean, minimalist look.

KEY IMPROVEMENTS & FEATURES

• 2.4x Greater Leverage: Vertical screw distance increased from 70 mm to 170 mm, reducing top anchor pull-out force by over 58%.
• Large Wall Contact Surface: Over 135 cm² of flat contact area spreads the load and prevents drywall crushing or wobbling.
• Hidden Fastener System: Includes matching snap-in caps that sit completely flush with the front face, hiding all screw heads.
• Guitar Pick Pry Notch: A subtle 3 mm notch inside each pocket lets you pop out the caps easily using a guitar pick without scratching the part.
• 100% Support-Free: Both the mount and the caps print completely flat on the bed with zero supports needed.

HARDWARE & MOUNTING SPECS

• Recommended Anchors: Drywall butterfly / toggle anchors (10 x 50 mm) or heavy-duty hollow wall anchors.
• Screws: 3.5 x 55 mm countersunk drywall/wood screws (holes feature a 4.2 mm bore with a 90° countersink below the cap pocket).

PRINT SETTINGS

• Orientation: Flat on the build plate (back side down). No supports required.
• Material: PETG recommended for long-term load bearing (PLA+ / PLA-CF also suitable).
• Walls / Perimeters: 4–5 walls (ensures a solid core around screw pockets).
• Top / Bottom Layers: 4–5 layers.
• Infill: 25–30% (Gyroid or Honeycomb).
• Caps: Print flat side down at 0.16–0.20 mm layer height for a smooth top finish.

Tagi