Lateral roller fitting for ball bearings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a fitting for mounting ball bearings laterally on boards (plywood, particle board), i.e. as sideways rollers.…
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 30
- Wydruki
- 1
- Wyświetlenia
- 226
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Public Domain
This is a fitting for mounting ball bearings laterally on boards (plywood, particle board), i.e. as sideways rollers. It is configurable for various ball bearing sizes with Customizer. Default settings are 16mm board and 608Z ball bearings. Not all combinations will work as intended.
The axle I used was an 8mm aluminum pipe.
You'll need to saw a slot into the side of the board since the design is set to have the axle rest against the edge of the board (less load on the plastic part).
Print Settings
Printer:
TronXY X5S
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.3mm layer, 0.6mm nozzle
Infill:
15% Honeycomb
Notes:
The printer needs to be able to bridge the slot for the ball bearing. I had no issue using 608Z bearings (some 8mm to bridge), but wider gaps might cause problems.
Category: DIY