Dell 11th/12th Gen Storage Array Rack Ear Adapters
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These adapters allow you to adapt a 14th+ gen "honeycomb" 2U server bezel to 11th/12th gen storage arrays.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 39
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
There are many adapters on the market for using 14th gen or new bezels on servers. The storage solutions from the same era uses different mounting points for the bezels, so those adapters will not work. These will allow a 14th gen bezel to clip on with no permanent changes to the storage array or bezel.
When installing, loosen the screw that lock the array to the rails, press the adapters on, hold them straight up and down as the screw is tightened. Install bezel normally.
Originals were printed in PLA for test fitting (as seen in pictures). Recommend a filament that won't creep with a little bit of heat. PA6-CF was used as that's what was sitting around for the final pieces.
Have confirmed fitment on the following devices:
Powervault MD1200
Powervault MD1220
Powervault MD3200
Powervault MD3200i
Compellent SC200
*Note - If a drive needs to be removed from the array on either end, the adapter will need to be removed as it partially blocks the drives.
Print Settings
Rafts: No
Supporst: No
Layer Height: 0.2mm
Walls: 3
Infill: 25%
Filament: Inland Matte PLA or Fibron PA6-CF