1 / 1
Custom mount for a forceflow on a fungineers x7/x10 — zdjęcie 1

Custom mount for a forceflow on a fungineers x7/x10

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I created this mount to use with forceflow footholds.

Ocena
0 / 5
Polubienia
3
Pobrania
6
Wydruki
1
Wyświetlenia
73
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

It is custom made for my TPU griptape, but will work on regular grip tape or if you flatten your TPU knobs. I designed this to not interfere with the foot sensor. I printed in ASA flat side down.  This works with the hardware, print settings of the part you print in TPU that attaches to it located at:
https://makerworld.com/en/models/2138357-force-flow-footholds#profileId-2617786

I used flat headed m5 hex bolts to mount to the stompie. I removed the stompie. Saw where there was a good spot in the "honeycomb" of the stompie to drill a hole. nut on the underside.

Tagi