1 / 1
Banana Pi BPI-R4 — 2U rack mount for 10" racks (metal case) — zdjęcie 1

Banana Pi BPI-R4 — 2U rack mount for 10" racks (metal case)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mounts the BPI-R4 in its official metal case into any 10 inch rack. Honeycomb front panel, no supports, no straps — the

Ocena
0 / 5
Polubienia
1
Pobrania
2
Wydruki
0
Wyświetlenia
49
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

A 2U rack mount that puts a Banana Pi BPI-R4 in its official black metal case into a 10 inch rack.

It's built on the real EIA-310 hole pattern — 1U = 44.45 mm, 236.525 mm hole pitch, proper irregular vertical spacing — so it bolts into standard 10" rails, not just printed racks that use an evenly spaced hole grid.

How it holds

The case slides in from the back. Its front tucks under a short roof pressed against the front panel, so it can't lift, and two small screwed stops then lock it at the rear. Clearance is 0.6 mm all round. Plug an SFP+ cable in from the front and nothing moves — no velcro, no zip ties, nothing to cut when you want it out again.

The window is cut 1.5 mm smaller than the case face all round, so every port and LED stays clear while the edge is hidden.

Cooling

The R4 runs warm, and copper SFP+ modules get seriously hot. The whole front panel is honeycomb and the tray is skeletonised, so air moves through rather than around. Going 2U instead of a tight 1U also leaves room above the case. PETG is worth it here if you're running a 10G RJ45 module.

Tagi