ZS-X11H mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounting solution for ZS-X11H brushless motor controller boards.
- Ocena
- 5 / 5
- Polubienia
- 0
- Pobrania
- 18
- Wydruki
- 1
- Wyświetlenia
- 45
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The ZS-X11H are relatively inexpensive brushless motor controller boards, with hall effect sensors and PWM control. The only other mounting solution I found on Printables, did not provide any room for air flow and heat dissipation. Ideally, the heatsink should be mounted upward but this would get in the way of using the wire terminals on one of the sides when the board is mounted, so this is the compromise.
Use M2.5 10-12 mm long screws to secure the board to the mount, and M3 screws to attach the mount to wherever you need it.
As can be seen in one of the photos, I was only able to use 3 M2.5 screws because one of the power transistors was in the way. As long as you can use 2 screws to secure the board, it will be very secure already.
PETG recommended but PLA should also work fine. No supports needed.