1 / 1
TP-Link Roam Travel Router Wall Mount - TL-WR1502X / TL-WR3002X — zdjęcie 1

TP-Link Roam Travel Router Wall Mount - TL-WR1502X / TL-WR3002X

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Vertical wall mount for TP-Link Roam series travel routers. Fix mount to wall using screws or mounting tape and drop in.

Ocena
0 / 5
Polubienia
2
Pobrania
28
Wydruki
0
Wyświetlenia
75
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Compatibility

This mount is compatible with the following models:

  • TL-WR1502X (Tested and fits)

  • TL-WR3002X (Should be the exact same size, but not tested to confirm)

It will NOT fit models with external/moveable antennas (e.g. TL-WR1512X, TL-WR3602BE). With compatible models, simply slide the router in from the top, and it should hold securely.

Printing

Print upright, with the thinner end on the bed (should look like a "U"). Infill should be somewhat high to ensure sufficient strength (I printed with 100% infill as it only used ~10g more material). Supports should not be needed with PLA/PETG/most other materials, assuming your printer can handle small overhangs and bridging. Optionally, enable Brim to help with bed adhesion.

Recommended Print Settings:
  • Material: PETG

  • Nozzle: 0.4mm

  • Layer Width: 0.2mm

  • Infill: 100%

  • Supports: None

  • Brim Type: Outer brim only

  • Brim Width: 8mm

The mount is modelled to be ~0.2mm oversized (wall-to-wall) so that the router will slide in smoothly and fit securely. If you know your printer struggles with tighter tolerances, or if you print using a material with significant shrinkage (not PLA/PETG), you might want to scale the model up slightly before printing. Otherwise, just print the downloaded file and it should fit fine.

Usage

Use either two screws/nails or two strips of mounting tape to secure the mount to the wall. Then, insert the router from the top, with the TP-Link logo facing outwards.

Option 1: Hang from Screws/Nails

There are two screw/nail mount slots, vertically oriented along the back, which allow the mount to be hung on the wall. The two screws/nails must be exactly 30mm apart and the heads must be no more than 3mm in height. Some common sizes that should be compatible include #6 Screws, M3.5 Wood Screws, etc. Best to test fit before putting a hole in the wall.

Hole Spacing (Between Centers): 30mm

Max Head Diameter: 8mm

Max Head Height: 3mm

Max Thread Major Diameter: 4mm

Option 2: Attach with Mounting Tape

Alternatively, place two strips of mounting tape in the recessed channels along the back. These channels can accommodate strips up to 13mm wide and up to 42mm long, though you may not need that much to secure it as the router and mount are both relatively light. The channels are only 0.6mm deep, so most foam-based mounting tape should be more than thick enough to work. Failing that, tape can be placed on any other flat part on the back.

Mounting Tape Width: ≤13mm

Mounting Tape Length: ≤42mm

Mounting Tape Thickness: >0.6mm