LG l204wt monitor base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement base for the stand of a LG l204wt Flatron monitor.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 11
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
Made this base to replace the missing one in my LG l204wt monitor.
You can either print it in two colors by using the 3mf file directly or print the base and logo STL at the same time choosing different colors for each, or just print the base STL if you only want a light engrave.
You can modify the .step file to adapt it to another monitor or any number of things.
This are the screws I used, you'll need two. The nuts are not necessary since it screws into the plastic quite well, but I had them so I put them.

The "stand_screw_spacers" are to be inserted in the square holes of the monitor stand so the screws hold it in place snuggly. The two longer ones go in the curved front while the short ones in the flat back, the side against the print bed should face the outside when inserted, and the different corners each one goes to are the same as the position when printed, so don't mix them up.
I wouldn't use more than 5% or 6% of infill as it would be unnecessary.
The feet are to prevent it from sliding around so they are optional, but should be printed in TPU.