1 / 3
Land Rover Discovery 1 radio head unit bracket and fascia — zdjęcie 1
1 / 3

Land Rover Discovery 1 radio head unit bracket and fascia

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A single din surround and front face to mount a headunit

Ocena
0 / 5
Polubienia
6
Pobrania
37
Wydruki
0
Wyświetlenia
205
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

This model is a complete mount and fascia for fitting a single DIN headunit in the Land Rover Discovery 1.
It might require some modification to the existing surround, as my car had broken plastic that I've excavated to give me access to the metal bracket to which I screw my new 1DIN cage.

The cage is pushed forwards in my model so that an extending 7" screen can find outward without fouling the surrounding plastics.

The model is in multiple parts that should allow you to print with different thicknesses for the spacers where needed, but are scaled to what I used in my photo. 

Printing:

  1. Print the cage with the bracket flat on the bed.

  2. Print the rear filler -  you can scale vertically up or down if you need your headunit to sit further forwards or back.

  3. Print the front filler - you can scale vertically up or down to some degree if required to get the fascia to sit as you like it.

  4. Print the fascia with the lettering facing down - handy it you have a textured plate.

None of the parts need supports and I would suggest using PETG or better to resist warping from heat.

Assembly:

  1. Slide the cage over the headunit such that the bracket with holes is nearest the front of the unit  with the holes at the back and underneath.

  2. Screw through the front filler, then the cage bracket, then the rear filler and into the metal dashboard mount. The bottom of the pieces have rounded corners so get them up the right way.

  3. The screws need to go in far enough to securely hold the cags onto the metal plate and to recess into the front filler

  4. Press the DISCOVERY fascia into place. It should stay in place or use double-sided tape to hold.

Additional parts:

  1. I used 5mm x 60mm single thread screws to mount my unit. You might prefer machine screws if the metal bracket still has thread in it. The length of the screws need to be enough to fit through the narrower section of the front filler, then the cage bracket, then the rear filler and into the metal dashboard mount

  2. I stuck thick tape on my headunit behind the cage, so stop it from sliding out forwards. You may prefer to add holes to the side of the cage to screw into the headunit but I did not provide any.

Options:

There's a 190mm fascia and a 175mm fascia. Both fit in the same way. The 190mm will almost fill the width of the dash whereas the 175mm will match the width of the headunit.  Take your pick.

Tagi