TRMNL DIY 7.5'' screen holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for the TRMNL DIY edition e-ink screen: handy to hang it in the kitchen with enough options for the USB-C cable
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 15
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
I wanted something that looked nice and could easily fit the hardware in and hang it in the kitchen with either tape or via some screws. Since I wasn't able to find anything online at the time I began developing my own.
The result is what you see. For this model to work properly, you need 4x 20mm M3 screws and 2-4x 5/7mm M3 screws, 8x M3 brass heat inserts, 1 small piece of double-sided tape (to hold the battery).
The model consists of 3 parts: you should first print all 3 parts and solder in the 4mm heat inserts. 2 are more than enough to hold the PCB but I would recommend to solder in all 4 of the outer ones.
You can then screw in the PCB and with the double-sided tape also put the battery in. If you're going for portrait mode ensure to put the battery kind of in the middle so that it if you use the screw hole it will level off.