INBXX Maintenence Door Hinge using M3 Bolts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the maintenance door hinge for the INBXX to use M3 screws, instead of print-in-place.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
The hinge on the INBXX is print-in-place. The default one for me was fused. There are alternate tolerance versions, but having to ‘crack’ it (especially if it needs a vice and hammer, which for stronger materials, it might) doesn't sit well with me.
NOTE: This is technically a remix of the hinge of INBXX, but they don't allow remixing, so I can't attribute it as such.
Replaces: Misc/maintenance_hinge-a1.stl (and the 030/035/040mm variants in "Alernative parts", which are not needed here)
HARDWARE
2 x M3 socket head cap screw, between M3 x 60 and M3 x 70 (inclusive).
PRINTING
No supports needed. The only unsupported geometry is the roof of the horizontal pin bore, which bridges fine. Everything else matches the stock part.
Suggested: 0.2 mm layers, 4 perimeters, >=30% infill. PETG / ASA / ABS / PC. PLA works but will creep under a permanently loaded hinge.
Print one of each. (For the double version of the enclosure, print two of each.)
ASSEMBLY
1. Lay both leaves flat on the bench, bottom faces down, and slide them together so the barrels interleave. They are not captive - they will simply sit together. The bores line up on their own.
2. From ONE end, feed an M3x60 into the end face of leaf A. It runs free for the first 52 mm - a 3.5 mm clearance bore through leaf A's end barrel and then all of leaf B's 40 mm barrel - before it reaches leaf A's centre barrel, where a 2.5 mm hole with a 45 deg lead-in makes it cut its own thread for the last ~7.5 mm.
3. Repeat from the other end.
4. Drive each screw until the head bottoms in its 5.8 mm counter bore. It will finish about 0.2 mm below the end face. Do not keep tightening - the head seating is the stop. Both the head bearing face and the thread are in leaf A, so the load closes through leaf A's own body; leaf B is never squeezed and the 0.45 mm axial gaps stay open. Over tightening only bows leaf A.
The hinge should swing freely straight away. If it is stiff, the screw is almost certainly cross-threaded or the bore has a print artifact; run a 3.5 mm drill through leaf B's barrels by hand and try again.