Columbian 504 1/2 bench vise thrust bearing upgrade "shroud"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
i'm pushing the limits of "niche" with my models these days but you never know!
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 17
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
As I said this is very niche but you are here you already looked for it and found it so here you go! I recently upgraded the original thrust washer arrangement on my vintage 1960s Columbian "504 1/2" ductile iron bench vise, (4.5 " jaw width,~ 7" opening, fixed base, no anvil) which had used a notched flat steel washer between a recesss in the front outside face of the dynamic jaw and the backside of the spindle hub/meatball (the center of the handle). On the inside of the jaw there is a plain steel washer ( the graphite impregnated bronze thrust washer is long gone and a screw collar with a set screw which remained unchanged although I did have to flip the collar 180 deg to accommodate new taller stack of hardware outside. The upgrade consists off two regular hardware store thick zinc washers, nominally 5/8" (5/8" ID, 1 3/4OD x 1/8 thick) which i bored out with a step drill to a generous 7/8" to fit the vise spindle. and then deburred and filed/sanded face smootheand a sandwich of "NTA 1247" thrust needle bearings and associated hardened washers (ID 7/8" x 1 11/16" OD x 5/64")
Although the face of my dynamic jaw recess was reasonably flat I wanted to support the thrust bearing as best I could so backed it on both sides with the thick zinc washers. stacked washer-thrust bearing sandwich (itself a washer-bearing-washer)-washer between the spindle nut and the dynamic jaw face. plus some generic red bearing. grease; it creates a supremely low friction rotating joint especially under load. theorreticallyincreasing effective clamping force by a much as 40-50%, plus given the wallowed out warped state of my stock thrust washer it def. couldn't hurt. But it did mean that a sticky washer and rather delicate needle bearing arrangement was exposed to the exact stuff you do'n't want in there, namely grit, grinding dust, and chips. SO it needed a flexible shroud (boot?) that covers the bearing and grease and can flex when and if it get pressed against the jaw face. and that is what this is. Voila!
if you have this mod in mind and want more details l just ask! tried modeling it from scratch but ended up using the popular vacuum adapter open scad file floating around good luck! printed on my qidi q2 in S black Sunlu TPU 95a, w/ stock profile settings. oh! Print flared side down! the flared size over thewshers and bearing, the "straight" side slips over spindle nut!