Corner Mount for AI Nero 3 - 45° Magnet Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds an AI Nero 3 at 45° in a back corner on the pump's own magnets. Press fit, no supports, PETG.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 134
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Holds an AI Nero 3 powerhead at 45° in a back corner of the tank, out of sight, using the pump's own magnets. No suction cups, no glue, no drilling.
Two printed parts:
- Base: holds the Nero's wet-side (inner) magnet against the glass, with legs rising to a 45° hex peg.
- Cup: snaps onto the peg. The pump presses into 8 fingers and sits on a rim ledge. The back stays open so the honeycomb intake isn't blocked, and the cable exits through a notch in the wall.
The outer magnet goes on the dry side as usual. To aim the flow, turn the base on the glass, or pop the cup off and re-seat it on a different hex flat (six positions). The pump guard has to be off.
PRINT SETTINGS
PETG (don't use PLA in saltwater). No supports for either part, in the orientation the files load in. 5 mm outer brim on the base. 0.2 mm layers, 4-5 walls, 40%+ infill. Rinse and soak in RODI water for 24 hours before it goes in the tank.
ASSEMBLY
1. Press the wet-side magnet into the base ring. Firm thumb pressure, and it should end up sticking out about 0.5 mm on the glass side.
2. Snap the cup onto the hex peg, cable notch facing the corner.
3. Guard off the pump, line the cable up with the notch, press the pump in until the rim sits on the ledge.
4. Base on the side glass near the back corner, outer magnet on the dry side.
Built around a measured Nero 3: magnet 45.5 mm across and 9 mm thick, pump body 60 mm across.
An independent design, not affiliated with or endorsed by AquaIllumination. My own geometry, measured from my own pump, not derived from anyone's files. Non-commercial use only. Works at your own risk: it's a printed part holding a pump over water and livestock.