Self-Locking Fishing Rod Holder – gravity latch, no spring (Butt Lock style, 3/8" BSF)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Put the rod down and it locks itself: the grip's weight tips a lever, a hook swings over it. Lift to release. No spring.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 168
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A rod holder that locks the rod by itself when you put it down – and opens by itself when you lift it. No spring, no snap hook, nothing presses on the grip or the blank.
How it works: the grip rests on the pedal of a lever that pivots on a printed snap pin. The weight of the grip tips the lever and its hook swings over the grip, stopping 1 mm above it. Lift the rod and the grip pushes the hook up; the lever falls back open. Without a rod the lever stays open on its own (centre of gravity sits beside the pivot). It closes with as little as 10 g of grip weight and only releases after the rod has been lifted about 20 mm – a knock against the bankstick will not do that.
Two parts, both print flat, no supports: body with 3/8"-20 BSF bankstick thread (or wall plate), and the lever. Push the lever onto the snap pin until it clicks, tip it five times, done.
Included files (default sizes):
• Rutenhalter_Verriegelung_Griff22mm_Bankstick – grip Ø 22 mm (Duplon), bankstick thread
• Rutenhalter_Verriegelung_Griff25mm_Bankstick – grip Ø 25 mm
• Rutenhalter_Verriegelung_Griff25mm_Wand – wall plate, two countersunk screws
Other grip diameters, tube clamp version, custom clearance: free at https://duesenwerk3d.de/modell/rutenhalter_verriegelt/ – enter your measurements, download STL or 3MF. No account, runs in the browser.
Printing: 0.2 mm layers, 3 walls, 20 % infill, no supports. PLA is fine (nothing flexes); PETG for the pin if you take the lever off often, PETG or ASA for permanent outdoor use. Pin clearance is 0.3 mm – if the lever is stiff, print the lever with 0.4 mm clearance from the generator.
— Deutsch —
Rutenhalter, der die Rute beim Ablegen von selbst verriegelt: Das Griffgewicht kippt eine Wippe, ihr Haken schwenkt über den Griff, ohne ihn zu berühren. Anheben öffnet. Ohne Rute steht die Wippe von selbst offen. Zwei Teile, flach, ohne Stützen, Wippe auf den Schnappzapfen drücken. Für Bankstick (3/8″ BSF) oder Wand; andere Griffmaße und Rohrschelle kostenlos nach Maß auf duesenwerk3d.de.