Strong Ceiling Filament Spool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Strong ceiling or wall spool holder for secure, space-saving filament storage in vans, caravans and small workshops.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 2
- Wydruki
- 1
- Wyświetlenia
- 29
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Ceiling or wall-mounted filament spool holder
This filament spool holder was designed to make use of otherwise unused ceiling space. It can also be installed vertically on a wall if that arrangement is more convenient.
Its solid mounting system makes it particularly suitable for confined spaces and demanding environments where the spool must remain securely attached. This includes camper vans, caravans, motorhomes, mobile workshops and other moving habitats.
Versions
Two versions of the mounting part are available:
Plain version
ERS 115 branded version, as shown in the photos
Material
PETG is recommended for better strength, durability and temperature resistance, especially when the holder is installed inside a vehicle.
PLA can also be used for indoor applications or environments that are not exposed to significant heat.
Included parts
Ceiling or wall mounting bracket
Filament spool retaining part
The supplied STL parts measure approximately:
Mounting bracket: 67 × 64 × 70 mm
Spool retaining part: 98 × 98 × 17 mm
Choose screws and wall plugs appropriate for the mounting surface and the expected spool weight. For installation inside a vehicle, make sure the support is firmly attached to a structural panel or reinforcement rather than to a thin decorative covering.
Material: PETG recommended; PLA also suitable
Walls: At least 4 perimeters recommended for a strong mounting
Infill: 30% or more recommended
Make sure the mounting holes and load-bearing areas are printed strongly enough for the weight of the spool and the intended installation.