Parkside PWD 20 C3 – Angled Swivel Hose Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My modified swivel connector housing, featuring an extended, angled handle for the Parkside PWD 20 C3.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 94
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Share Alike
Parkside PWD 20 C3 – Angled Swivel Hose Handle
My modified swivel hose connector for the Parkside PWD 20 C3, featuring an extended, angled handle.
The original handle is fixed to the hose, causing it to twist during use. This design allows the hose to rotate independently of the handle, making vacuuming more comfortable.
All parts needed for the swivel assembly are included, together with the modified handle housing.
Assembly tip
Screw the corrugated vacuum hose into the threaded connector counterclockwise.
To help the hose engage with the thread, cut a small notch into one side of the hose end at a raised rib. This helps the edge follow the spiral of the thread as you screw it in.
Adjusting the fit
If the swivel feels too tight or doesn't rotate freely, try printing the inner part at 99.5% scale and the outer part at 100.5% scale.
For more clearance, you can try 99% for the inner part and 101% for the outer part.
For me 100% works fine. I made mine from PETG with 4 perimeters 100% infill, 0.15mm layer on Prusa Mini Bear. + BRIM.