1 / 5
Magnetic dosing funnel for Lelit 57mm portafilters — zdjęcie 1
1 / 5

Magnetic dosing funnel for Lelit 57mm portafilters

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Dosing funnel for 57mm Lelit portafilter with magnets embedded inside the model

Ocena
0 / 5
Polubienia
1
Pobrania
6
Wydruki
0
Wyświetlenia
21
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Dosing funnel for Lelit Anna 57mm portafilters that stays in place!

After long time of using existing 57mm WDT tools 3d printed, and using funnels designed to work with those tools, I got tired of them not staying in place, sometimes staying in place too tight. So, this is my first model with magnets embedded inside! 

Compared to other funnels from AliExpress/Temu, this one, with 9 6x2mm magnets, stays in place even upside down, wiggling. Tolerance for magnet holes is pretty tight (6.1x2mm) but that's what was working for me. Actually, model on the photos has 6x2mm holes, but putting magnets inside was rather hard and could result in model separating from plate.

Existing project should be paused at the beggining of layer 108 (0.2mm layers), so if you want to reuse raw model, do not forget to put it in there too. On top of that, model is laying upside-down to avoid printing any supports, which worked for me on CryoGrip plate, this might not work for you, as top lip is narrow and might separate from the plate, so consider it.

Tagi