1 / 9
Drink Holder - Homland Walker (and others) — zdjęcie 1
1 / 9

Drink Holder - Homland Walker (and others)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a custom drink holder to fit a Homland walker and possibly some other brands.

Ocena
0 / 5
Polubienia
2
Pobrania
5
Wydruki
0
Wyświetlenia
50
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Drink Holder - Homland Walker (and others)

This is a custom drink holder to fit a Homland walker. Some other brands appear identical and this may work for them. The walker style is wheeled, with hand brakes and has a curved seatback tube with a foam backrest across the front. The main tube and the backrest tube are at about a 90 degree angle to one another. The backrest tube is slightly smaller than the main tube. If your walker meets that description this model will probably work for it.

There are two parts, a base that clips to the walker frame tubes (with provisions for Velcro straps or Nylon cable ties, if needed) and a removeable drink holder cup with a socket that slips over the post on the base. The holder rotates on the post so can be positioned outside the frame if using the walker seat or inside the frame to more easily pass through doorways.

The base can mount on either side of the walker. The walker will still fold up with the drink holder installed.

In addition to the post socket, the holder cup has a slot for a cup/mug handle and a pair of flat areas for a phone clip.

There is a semicircular hole above the lower tube clip for passing a Velcro strap or a cable tie through. The hole is about 15 mm wide. I used a 12 mm Velcro strap and it fit OK.

EDIT 9/23/26

The post portion of the base in the original design is weak across the layer lines. I've modified the design to make the base in two pieces, glued together. Those can be printed easily with the flat side down. This avoids the layer lines being perpendicular to the axis of the post and thus much more resistant to breaking.

I've incorporated three 3 mm dowel pin holes in the flat faces of each half to fit M3 X 8 mm stainless steel dowel pins. The pin holes are 5 mm deep in each half. The pins are optional but make alignment for gluing easy. The holes always print a little undersized so they need to be cleaned out with a 3 mm drill in a pin vise if you choose to use them. Glue the base halves together with cynoacrylate gel.

I've added files for parts "Base - Left rev 3.stl" and "Base - Right rev 3.stl". Use those instead of the original file "Base rev 3.stl"

The shell thickness and infill parameters are both increased in the print parameters list at the bottom.

END EDIT

The holder is an easy print; the base, not so much. I printed in the orientation shown with tree supports and it worked OK, but I had to add a pair of small cylinders to the model, across the ends of the shorter tube clip to keep them in place until they tied together. Those must be removed after printing. See image.

With the parameters below the model uses about 72 m of filament.

Print Parameters, both parts:

- Material: PLA

- Layer Height: 0.2 mm

- Nozzle:0.4 mm

- Shells: 0.3 mm (edited)

- Infill:24%

- Supports: Yes (tree supports worked best)

Tagi