Tri Tube Guide
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This guide helps keep your two filament tubes and wiring going to the hot end organized.
- Ocena
- 4,667 / 5
- Polubienia
- 6
- Pobrania
- 44
- Wydruki
- 2
- Wyświetlenia
- 329
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This guide helps keep your two filament tubes and wiring going to the hot end organized. This should also help the wiring bend along the full radius of its length instead of just by the head. This guide will work on a Flashforge Creator pro and probably on the Replicator and Replicator 2X, although the clips are sized for the Creator Pro specifically.
2015-21-07: Added fillets to all sides of the 3D model, this allows easier removal from the build plate when printing without raft. Added Bi Clip Guide version for single extruder setups.
Print instructions
Category: 3D Printer Accessories Instructions
Print, peel off build plate, hook over wire loom, snap in filament tube(s).
Suggested print profile: Low settings, no raft, no supports. Smaller clip inside diameter is made to snap over the filament tube provide with flash forge machines.