Aqara W100 Wall Mount, Slide In
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Slide-in wall mount for Aqara W100 Climate Sensor, holding secure while allowing easy access for servicing.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 40
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of conleth's W100 wall mount, with an open top and center retention pin rather than full surround snap-in retention. The hold of the original was too tight for my liking, making it a challenge to remove when performing battery replacement or factory reset if needed. Removing the top tab allows the W100 to be serviced by sliding in/out of the top of the mount while still providing a secure hold via the retention pin.
Additionally, the outside curve on the tabs was reworked to no less than 40 degrees from horizontal to clean up the print quality when printing without supports (recommended). The original curve angle was too steep at the start, so the edge quality suffered when not supported.