Flagging Tape Holder for Home Depot Tape
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a flagging tape holder/dispenser for the flagging tape rolls sold at Home Depot (1 inch tall by 4.75 wide)
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 26
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model was made specifically for the Home Depot flagging tape rolls. They are 1 inch tall by about 4.75 inches wide and a hub of about 1.4 inches. This may work for other rolls but of course measure first.
This can be carried by hand or a paracord loop can go through the middle, but I also included a simple belt/pocket clip that snaps into the cap portion of the holder. The clip is not very aggressive so if you need strong holding power go with a cord loop. If you want to remove it after snapping it in it's best to unscrew the cap from the body and that will give you access to the snap tabs where you can flex them to pull the belt clip back off.
These tabs work great when used as intended but because of the print orientation they will snap if over-flexed.
To keep the tape tidy while dispensing make sure to thread it through the retention slot on the outside of the body.
This was printed in PETG at a 0.20 layer height on an MK4S.