UglyCase
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An ugly case for the BC-250 mining/gaming board.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 69
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A basic case for the Asrock Rack BC-250 mining/gaming board. Work in progress at https://github.com/sshockley/UglyCase.
I originally printed one of the MK-Ultra cases, but it was a little bit too flexy for me. I was getting rusty at FreeCAD, so I brushed up and started drawing. It's probably excessively parameterized. I tried to make it so changing a parameter will automatically update any other measurements. I may have succeeded. If you modify the drawing you'll want to turn off "auto recalculate" or you'll be waiting after every parameter change.
I wouldn't consider this finished; there are some air leaks around the RAM heatsink on the back of the case, and I'd like to improve how the two halves line up.
I was able to run high loads with 40 CU (yay!) and 6 cores (boo!) and not break 85C. I probably can do better once I fix the leaks. The heatsink is unmodified.
Prints took about 10 hours for each tray and 2.5 hours for each lid on an Ender 3 Max Neo at 0.3 layer height with PLA. It should fit on a 200 mm bed but it's too big for 180 mm.
Ugly is in the eye of the beholder.