1 / 7
Toyota key housing (1999 yaris and relevant models) — zdjęcie 1
1 / 7

Toyota key housing (1999 yaris and relevant models)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a key housing to replace the original toyota keyfob for a 1999 yaris and similar models.

Ocena
0 / 5
Polubienia
1
Pobrania
4
Wydruki
0
Wyświetlenia
30
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a housing for the electronics of the original key for the 1999 yaris and similar models. The parts do not need any support to be printed and are fully customisable.

Materials: typical PLA works fine, maybe consider using PETG for extra robustness

Assembly guidelines: 2 part design, keep the original electronics, metal key and screw that holds the key together.

  • Step 1: From the original housing, remove the metallic key for the ignition.

  • Step 2: Position the electronics inside the top casing. The fit is snug so be sure to press slightly. Make sure that the buttons are positioned correctly inside their corresponding slots and that the led light is also visible. (pic 1)

  • Step 3: Take the screw from the original key and drive it through the screw hole at the bottom part of the housing. This ensures that the hole is threaded and makes it easier to later on during the assembly,

  • Step 4: Press-fit the key to the corresponding slot on the top half of the key. The fit is snug, so give it a little push! The orientation of the key does not make that much of a difference, but you can follow the guidelines in the images if you are not sure, (pic 2)

  • Step 5: Take to bottom half and slide the back hinge into the corresponding slot at the top half. The bottom half should rest at, around, a 20 degree angle relative to its other half. By pressing slightly on the hinge, and pushing toward the front, the two parts should fall into place. (pics 3, 4 and 5)

  • Step 6: Screw everything together!

  • Step 7: Enjoy your new key!

Tagi