1 / 3
Rim Holder for 250ml Cans — zdjęcie 1
1 / 3

Rim Holder for 250ml Cans

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A quick little snap-on rim holder for 250ml redbull cans.

Ocena
0 / 5
Polubienia
5
Pobrania
4
Wydruki
0
Wyświetlenia
32
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A parametric top-rim can carrier for 250 ml cans, designed in OpenSCAD. Instead of cradling the cans around their bodies, it clips onto the rolled top rim.

Push the carrier straight down onto the can tops and a ring of flexible fingers at each socket splays over the chime and snaps under it. You can lift the whole set by the finger holes and pop any can out with a quick push.

I've been printing them upside-down with organic supports for the clips.
They've been designed for a 0.1 or 0.2mm layer height.

Tagi