Pebble Time 2 22mm Strap / Velcro Wristband Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A watch strap adapter to use 22mm straps / Velcro wristbands with the Pebble Time 2 / PT2 smartwatch.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 41
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
This is an adapter to use 22mm velcro watchbands with the Pebble Time 2 smartwatch.
It was tested with the Garmin Ultrafit nylon watchband but most likely also works with other ~2mm thick 22mm straps and other with watches that use 22mm / 1.8mm quick-release spring bars.
It comes in a 3mm thick and a thinner 2.4mm version. I use the 3mm version but if you like a slightly tighter strap bend radius you can use the thinner version.

Printing
Print 2 Pebble Strap Adapters. Print the parts in the original orientation. All files are pre-rotated for printing.
Print the part fully solid by bumping the perimeter count. Infill is not needed.
Material: PLA, PETG, ASA, etc.
Layer height: 0.2mm or 0.1mm
Extrusion width: 0.4mm or 0.45mm
Perimeters: 6
Infill: 0%
Installation
Step 1 - Remove Quick-Release Spring Bar
Using a small tool or your fingernails, open up the hole on the side of the silicone watch band and push the quick-release spring bar out.
It's a little fiddly but not hard. A quicker but destructive method is to slice the watchband open with a blade and retrieve the spring bar.
Remove them from both parts.

Step 2 - Install Quick-Release Spring Bar
Push the quick-release spring bars into both printed Strap Adapters. If it doesn't fit or there is obstruction, ream the holes with a 1.8mm drill bit (or 2mm if you don't have 1.8mm).

Step 3 - Install Strap Adapters
Install the Strap Adapter on the watch body. Insert the side without the lever first, then pull the lever to retract the pin, align it with the second hole on the watch, and release the lever. Repeat for the second Strap Adapter.

Step 4 - Install Watchband
With the Strap Adapters installed and hinging nicely, thread the watchband through the slots as shown.

Remixing
STEP files are available in the Files tab.
If you would like to modify the design or change some of the dimensions, create a copy to edit in Onshape.
Additional Credits
The Pebble Time 2 watch body used for reference and for the illustrations can be downloaded from the Core Devices GitHub repo.