1 / 1
Pedestal Base and Fan Shroud for Orbi RBE371 Base & Satellites — zdjęcie 1

Pedestal Base and Fan Shroud for Orbi RBE371 Base & Satellites

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I like my network equipment to run cool for life & stability. Fan shroud for 80mm fan and a stable Pedestal Base RBE371

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
15
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

Over the years I have found the best life and stability comes from cool network equipment.  I had a lot of trouble with heat in the past with Actiontec equipment, so when I upgraded to an Orbi RBE371 mesh system with two satellites, I made these fan shrouds and Pedestal Bases for each as a precaution. 

The Pedestal follows the curvature of the router and secures with two metric screws. It makes the tall router and fan much more stable.

The top fan shroud is a friction fit to the top of the router and is sized for a 80mm fan.  I used an Antec 12V DC temperature controlled fan, so it is very quiet and is just barely turning, and runs off the router power supply.  The fan grill and fan are secured with Qty(4) 1.25 inch long 6-32 screws.  I tapped the shroud holes with a 6-32 tap.  I made a female to male  5.5 x 2.1 mm power connector and soldered the fan power to it.  Then covered with a length of heat shrink for a tidy installation.

Tagi