Metabo TS series Sliding Table 400mm 3/4" T Track
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Extended table with 19mm (3/4") T track to use precision miter gauge on Metabo TS Sliding Table (628900000)
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 131
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The standard miter gauge that comes with the Metabo TS sliding table (628900000) works but is rather limited. There are plenty miter gauges available that do allow accessories like end stops and extensions. Unfortunately the T track used by Metabo, both on their table saws as on the sliding table, is not very common. Even though one could print these tracks, it's quite hard to change an after market miter gauge to fit the Metabo T track and maintain some accuracy. I thought it would be much easier to re-engineer the table in a way that one can still use the sliding mechanism and add an aluminium T track insert.
400mm is too large for my printer, so I made it into 2 separate parts that join together. The files have zero tolerance so joining them can be tricky, especially when the first layer is wider than the rest. I managed to join them with some gentile tapping with a rubber hammer.
The T track is mounted using 3 countersunk M5x10 screws and 3 M5-S threaded inserts in the printed part. The sliding mechanism is attached to the new table with 4 M6x16 bolts with washers that go into 4 M6 threaded inserts.
The M5 knob secures my Vevor miter gauge to the table. These miter gauges only slide in the track and can't be secured by tightening it, like the original Metabo miter gauge.
The original Vevor knob uses M6 to secure its angle position. In order to keep the miter gauge as is, I opted to use an M5x40 bolt in the knob (secured by the knob insert) that goes through the M6 hole of the miter gauge and I drilled/tapped M5 thread in the aluminium T-track. This secures the miter gauge to the sliding table. As this can be different for any miter gauge on the market, I didn't include that in the design.
There's a knurled version of the M5 knob made with Bumpmesh by CNC Kitchen.