Reloading Dies on Pegboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
As I liked the idea of having labels built into the holders for the pegboard as I am setting it up, as there is only a…
- Ocena
- 4,5 / 5
- Polubienia
- 34
- Pobrania
- 161
- Wydruki
- 1
- Wyświetlenia
- 839
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
As I liked the idea of having labels built into the holders for the pegboard as I am setting it up, as there is only a couple of designs for holding Dies on a pegboard but nothing with labels.
This is set up for standard 1" center pegboards
So far I have done up the following:
single die
223 - 2 die
303 - 2 die
308 - 2 die
7MM08 - 2 die
6.5 MS - 3 die
458 Webley - 3 die
6.5 CM - 3 & 4 die
300 win 4 die
9mm 3/4 die
300 blackout 4 die
45 4 die
40 4 die
243 4 die
38/357 3 die
30-06 2/4 die
380 ACP 4 die
The files labeled Large Display which do not open are a corruption from the process of the mass import as I have never actually save files with a label of Large display. So if you have downloaded any of those there is actually nothing there for you to use, sorry.
If anyone would like a set done up message me and I'll do it up when I get a chance
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.2
Infill:
10
Filament: spool3d PLA
Notes:
I had used raft only because I needed to due to how prints are adhering to my bed right now. and I found 10% cubic is lots of strength for this design. As well I used Tree supports.
Category: Other