Panda Breath power cord passage for Centauri Carbon
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A panel grommet for allowing the Panda Breath power cable to exit the printer via the left panel
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 32
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- BSD License
I installed a Panda Breath unit in my Centauri Carbon. I had seen other options to allow for routing the power cable but was not keen on the majority of the power cable remaining in the machine, I also didn't want to cut the power cable if I could avoid it.
My solution was to cut a hole in the left side panel where I mounted the Panda Breath and make a small insert to cover the hole to prevent the cord from rubbing on the steel.
The model consists of 2 parts to aid in making the print require no supports.
To install the part you need to cut a rectangle hole in the bottom of the left side panel. The hole needs to be 20mm wide by 40mm tall. Be sure to file the raw edge to debur it as it will be very sharp. After which the part is designed to slide into the hole from the bottom and seat. One part of the model is deliberately shorter than the other. This part faces inward to clear the lip of the frame.
Once done you route the cable through it and run it along the side of the printer. This makes the installation easier since the power inlet for the machine is on the left side too.
Afterthoughts
Looking back on the design 40mm of height was probably too much, but since I already cut my panel I am pretty much stuck. The part could be resized to fit a small cut out and still achieve the same goal. Maybe 20mm x 20mm. I might create a variation on this for download.