1 / 7
Heavy Duty Battery Powered USB-C Solder Fume Extractor Remix — zdjęcie 1
1 / 7

Heavy Duty Battery Powered USB-C Solder Fume Extractor Remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Wireless fume extractor remixed with USB-C, M3 heat inserts, custom 2S 18650 base, and an extended intake flange.

Ocena
0 / 5
Polubienia
9
Pobrania
30
Wydruki
0
Wyświetlenia
212
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This remix adapts the original wireless design to utilize standard M3 hardware, modern charging interfaces, and simplified electronics. The primary goal was to make the build more accessible using common workshop components without relying on expensive hardware like Noctua industrial fans.

All structural mounting points were modified to accept M3x5mm brass heat set inserts. The charging circuit was upgraded from a 2.1mm barrel jack to a USB-C input. To simplify the build and cut costs, the dedicated PWM controller was removed. Since generic 120mm axial fans operate at acceptable noise levels, the fan speed can be statically tuned by adjusting the voltage trimpot on the DC-DC Buck/Boost converter.

The base was re-engineered to hold a 2S 18650 battery pack and features a front-facing digital battery meter for quick capacity checks. To improve fume extraction on the workbench, an extended intake flange was added, acting as a directional shroud. A custom clip locks the housing halves and the new flange tightly, ensuring structural rigidity.

File Dependencies: This is a partial remix. To complete the physical assembly, you MUST download the main fan enclosure from the original author's project page. 


Required Hardware:

  • M3x5mm Threaded Heat Inserts

  • M3x6mm Socket Head Screws (Standard Allen head)

  • 120mm Axial PC Fan & 120mm Carbon Filter Sponge

  • 2x 18650 Battery Spring Plate (18,5x16mm)

  • 2S 18650 Battery Holder & two 18650 cells

  • Rocker Switch 250V 3A KCD1

  • XL6019 DC-DC Buck/Boost Converter

  • IP2326 USB-C Charging Module

  • 4-Segment LED Battery Capacity Indicator

  • [Recommended] 2S BMS Protection Board


⚠ CRITICAL SAFETY WARNING: NO DISCHARGE PROTECTION (BMS) This build uses the IP2326 USB-C module, which ONLY handles charging and balancing. It DOES NOT feature under-voltage lockout (UVLO) during discharge. The XL6019 step-up converter will continuously drain the 18650 cells below their safe chemical threshold (2.5V per cell) if the unit is left turned on. Draining lithium cells below this point causes permanent internal damage and poses a severe fire hazard upon the next recharge. If you build this exactly as documented, you MUST actively monitor the battery display and turn the unit off manually before the cells die. For a safe, unattended build, you MUST add a standalone 2S BMS protection board between the battery pack and the XL6019 converter.

Tagi