Earring and Jewellery Organizer with Optional Accessory Tray

This organizer provides a practical way to store and display different types of jewellery. It is available in two versions:

• Standalone earring organizer without tray slots

• Modular organizer with dovetail slots for the included accessory tray

The upright organizer contains nine separate compartments arranged in a 3 × 3 grid. They are ideal for keeping pairs of earrings separated, visible and easy to reach. Curved retaining edges prevent small items from sliding out while avoiding sharp internal corners.

The optional lower tray provides space for jewellery that does not fit naturally into the smaller compartments, including:

• necklaces and chains

• watches

• bracelets

• rings

• brooches and other small accessories

The tray connects to the compatible organizer using three sliding dovetail joints. No glue, screws or additional hardware are required, and the tray remains removable for easier access or cleaning.

If you only need the earring compartments, print the standalone version without dovetail slots. It has a clean, uninterrupted base and does not require the tray.

Smooth curved transitions inside the tray make small items easier to pick up. The curves are modelled as continuous surfaces rather than horizontal steps, helping prevent unnecessary bridge movements during printing.

Included files:

• Earring organizer with dovetail slots

• Standalone earring organizer without tray slots

• Removable jewellery tray with three dovetail rails

Dimensions:

• Upright organizer: 134 × 43 × 140 mm

• Nine nominal 40 × 40 mm compartments

• Tray area: 134 × 90 mm

• Tray including dovetail rails: 134 × 119 × 13 mm

• Tray bottom thickness: 3 mm

• Tray rim width: 4 mm

Assembly:
For the modular configuration, slide the three rails on the rear of the tray into the matching dovetail slots at the bottom of the organizer. The fit is designed for FDM printing in PLA. Depending on printer calibration, very light sanding may be required.

Printing:

• Print the selected organizer version in its supplied orientation

• The organizer is already oriented with its large rear wall on the print bed

• Print the tray flat on its bottom

• No supports required

• 0.20 mm layer height

• 3 walls

• 15–20% infill

• PLA or PETG

• A brim is normally not required